Date 2002-10-05
Provider: Eksitdata
Author: Niko Lupala
Editor: Amber Lupala
Well it's time to make a "How to apply a window applique" guide here at Red&Blackness.
So what is a window applique? Its like a see through sticker that you can put on your case window and then
put a cold cathode or a Lazerled that makes it look really sweet....
This Biohazard window applique came from Eksitdata but most modd/overclocker stores have these. So basically
it's not hard to find at all. Well I guess it's time to get the guide going before you get to bored and leave the page :)
Step 1
Clean and remove the covers/plastic from the plexi window. Step 2
Unpack and take out the applique itself.... Step 3
Here we can see that I've started to remove the semi-transparent sheet part of the applique-So do that now
This is how it's supposed to look like when you have taken the semi-transparent sheet off
Step 4
Spray the plexi so it gets a little wet!
Then put the applique on the plexi
Step 5
Time to start scraping the air bubbles out, do this really slowly and try to get as much as possible of the air bubbles out.
As you can see I'm using a card so find yourself a old credit card or something that is flat.
Then its time to pull the protective paper off, do this slowly so you see it sticks to the plexi.
Step 6
Wipe the plexi off so it dries, if there is any air bubbles left they will dissapear in a day or two when it dries.
Here we see the result. Now all you need is a lazerled or cold cathode to make it look great.
Conclusion
Easy to install and makes the case look sweet so go buy one the cost around 5$ so it's something even for the poor people (me) to :)
Special thanks to our sponsor Eksitdata that made this guide possible!
RSS
